Skip to main content
Inspection outcome
Opened: October 17, 2024 · Closed: December 27, 2024
Serious citation issued

OSHA cited the employer for at least one Serious violation.

Safety inspection · Planned (Programmed) · Comprehensive — entire establishment

Violations2
Serious+1
Initial penalty$17,629
Current penalty$15,000
Accidents0
Duration71d
Summary

What happened in this inspection

On October 17, 2024, OSHA opened Helmerich & Payne International Drilling Company’s inspection #347822025 at MENTONE, Texas. The case was administratively closed on December 27, 2024, 71 days after opening.

OSHA cited the employer for 2 violations totaling $15,000 in current penalties — reduced from an initial proposed total of $17,629. Of those, 1 was classified as Serious or worse.

Breakdown by classification
2violations total
Repeat150%

A Repeat violation means OSHA cited the employer for a substantially similar violation within the past 5 years. Penalties multiply (up to ~$165,000 per repeat citation) and indicate the employer failed to permanently abate a recurring hazard.

Other-than-serious150%

An Other-than-serious violation has a direct relationship to job safety and health but probably would not cause death or serious physical harm. Maximum penalty is ~$16,550 per violation. Often involves recordkeeping or procedural lapses.

Citations

Citations issued in this inspection

2citations issued
$15,000current penalty
↓ $2,629total reduction
Look up on OSHA.gov
Othergravity 5
Citation #01001
29 CFR 1910.132(a)View full regulation text on OSHA.gov
Initial$8,816
Current$7,500reduced by $1,316
Repeat
Citation #02001
29 CFR 1910.303(b)(7)(iv)View full regulation text on OSHA.gov
Initial$8,813
Current$7,500reduced by $1,313

Standard codes link to the regulation text on OSHA.gov. The text describes the rule itself; the specific findings of this inspection appear above. To see OSHA’s official record of this inspection, search activity number 347822025 at OSHA Establishment Search.

Same employer

Other OSHA inspections at Helmerich & Payne International Drilling Company

Earlier or related cases at this establishment.

Full inspection history →
Reference

About OSHA inspections

The U.S. Occupational Safety and Health Administration (OSHA) conducts inspections under several triggers: programmed targeting of high-hazard industries, employee complaints, workplace accidents, fatalities, and follow-ups to prior citations.

📋
Citations

Each citation specifies a section of 29 CFR, a severity tier, and a proposed penalty. Employers can contest citations through OSHA’s informal conference or before the OSH Review Commission.

Open vs closed

An open case has not yet been administratively closed — citations may follow or the case may close without action.

💰
Current vs initial penalty

Initial penalty is the proposed amount at citation. Current penalty is the post-conference / settlement figure on file today.

🔗
Trigger types

A = Accident, B = Complaint, H = Programmed, F = Follow-up. See the glossary for all codes.

About this inspection

OSHA classified this as Planned (Programmed) — a programmed (planned) inspection, typically targeting high-hazard industries.

Sources

Cross-check with OSHA directly

This page draws from the OSHA Integrated Management Information System (IMIS) via the DOL Open Data Portal. For the authoritative record, look up activity number 347822025 directly: