Skip to main content
Inspection outcome
Opened: July 29, 2025 · Status: Open
Accident-triggered

OSHA opened this case in response to a reported workplace incident.

Safety inspection · Accident-related · Partial — limited to specific operations or areas

Violations3
Serious+1
Initial penalty$212,850
Current penalty$212,850
Accidents0
Duration
Summary

What happened in this inspection

On July 29, 2025, OSHA opened All Fab Precision Sheetmetal, Inc.’s inspection #348414533 at SAN JOSE, California. The case remains open or the close date has not yet been published.

OSHA cited the employer for 3 violations totaling $212,850 in current penalties. Of those, 1 was classified as Serious or worse.

Breakdown by classification
3violations total
Willful267%

A Willful violation is one OSHA determined the employer committed with intentional disregard for, or plain indifference to, the OSH Act. It carries the highest civil penalty — up to ~$165,000 per violation. Willful violations are rare and signal the most serious workplace safety failures.

Serious133%

A Serious violation is one where there is substantial probability that death or serious physical harm could result, and the employer knew (or should have known) of the hazard. Maximum penalty is ~$16,550 per violation. The majority of OSHA citations fall into this category.

Citations

Citations issued in this inspection

3citations issued
$212,850current penalty
Look up on OSHA.gov
Willful
Citation #01001
342(A)General Duty Clause or unstructured citation
Initial$25,000
Current$25,000
Seriousgravity 10
Citation #02001
3203(A)(6)General Duty Clause or unstructured citation
Initial$25,000
Current$25,000
Willfulgravity 10
Citation #03001
4214(A)General Duty Clause or unstructured citation
Initial$162,850
Current$162,850

Standard codes link to the regulation text on OSHA.gov. The text describes the rule itself; the specific findings of this inspection appear above. To see OSHA’s official record of this inspection, search activity number 348414533 at OSHA Establishment Search.

Same employer

Other OSHA inspections at All Fab Precision Sheetmetal, Inc.

Earlier or related cases at this establishment.

Full inspection history →
Reference

About OSHA inspections

The U.S. Occupational Safety and Health Administration (OSHA) conducts inspections under several triggers: programmed targeting of high-hazard industries, employee complaints, workplace accidents, fatalities, and follow-ups to prior citations.

📋
Citations

Each citation specifies a section of 29 CFR, a severity tier, and a proposed penalty. Employers can contest citations through OSHA’s informal conference or before the OSH Review Commission.

Open vs closed

An open case has not yet been administratively closed — citations may follow or the case may close without action.

💰
Current vs initial penalty

Initial penalty is the proposed amount at citation. Current penalty is the post-conference / settlement figure on file today.

🔗
Trigger types

A = Accident, B = Complaint, H = Programmed, F = Follow-up. See the glossary for all codes.

About this inspection

OSHA classified this as Accident-related — an inspection triggered by a reported workplace accident.

Sources

Cross-check with OSHA directly

This page draws from the OSHA Integrated Management Information System (IMIS) via the DOL Open Data Portal. For the authoritative record, look up activity number 348414533 directly: