Skip to main content
Inspection outcome
Opened: April 14, 2020 · Closed: November 23, 2020
Accident-triggered

OSHA opened this case in response to a reported workplace incident.

Safety inspection · Accident-related · Partial — limited to specific operations or areas

Violations3
Serious+0
Initial penalty$9,975
Current penalty$5,710
Accidents0
Duration223d
Summary

What happened in this inspection

On April 14, 2020, OSHA opened J. S. West Milling Company’s inspection #344725155 at HILMAR, California. The case was administratively closed on November 23, 2020, 223 days after opening.

OSHA cited the employer for 3 violations totaling $5,710 in current penalties — reduced from an initial proposed total of $9,975. All citations were Other-than-serious.

Breakdown by classification
3violations total
Serious133%

A Serious violation is one where there is substantial probability that death or serious physical harm could result, and the employer knew (or should have known) of the hazard. Maximum penalty is ~$16,550 per violation. The majority of OSHA citations fall into this category.

Other-than-serious267%

An Other-than-serious violation has a direct relationship to job safety and health but probably would not cause death or serious physical harm. Maximum penalty is ~$16,550 per violation. Often involves recordkeeping or procedural lapses.

Citations

Citations issued in this inspection

3citations issued
$5,710current penalty
↓ $4,265total reduction
Look up on OSHA.gov
Othergravity 5
Citation #01001
3328(B)General Duty Clause or unstructured citation
Initial$525
Current$0reduced by $525
Other
Citation #02001
3314(D)General Duty Clause or unstructured citation
Initial$4,725
Current$2,000reduced by $2,725
Seriousgravity 10
Citation #03001
3999(B)General Duty Clause or unstructured citation
Initial$4,725
Current$3,710reduced by $1,015

Standard codes link to the regulation text on OSHA.gov. The text describes the rule itself; the specific findings of this inspection appear above. To see OSHA’s official record of this inspection, search activity number 344725155 at OSHA Establishment Search.

Same employer

Other OSHA inspections at J. S. West Milling Company

Earlier or related cases at this establishment.

Full inspection history →
Reference

About OSHA inspections

The U.S. Occupational Safety and Health Administration (OSHA) conducts inspections under several triggers: programmed targeting of high-hazard industries, employee complaints, workplace accidents, fatalities, and follow-ups to prior citations.

📋
Citations

Each citation specifies a section of 29 CFR, a severity tier, and a proposed penalty. Employers can contest citations through OSHA’s informal conference or before the OSH Review Commission.

Open vs closed

An open case has not yet been administratively closed — citations may follow or the case may close without action.

💰
Current vs initial penalty

Initial penalty is the proposed amount at citation. Current penalty is the post-conference / settlement figure on file today.

🔗
Trigger types

A = Accident, B = Complaint, H = Programmed, F = Follow-up. See the glossary for all codes.

About this inspection

OSHA classified this as Accident-related — an inspection triggered by a reported workplace accident.

Sources

Cross-check with OSHA directly

This page draws from the OSHA Integrated Management Information System (IMIS) via the DOL Open Data Portal. For the authoritative record, look up activity number 344725155 directly: